0

Out of 0 Ratings

Owner's of the iOptron Telescope SmartStar gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 38
 
6
2. Telescope Assembly
Step 1. Preparing the Tripod
Unlock the tripod leg locks (#10).
Extend tripod legs.
Lock the leg locks afterwards.
Step 1a.
Pull tripod legs apart to a fully opened position.
Tighten the center tripod lock knob (#9) to a firm feel to secure
the tripod legs.
Caution
: Make sure you loosen this lock knob before
collapsing the tripod to store away.
Step 2. Attaching the Mount
Position center of the mount base to the threaded bolt of height
extender (#13) on tripod.
Turn the mount until it is securely fastened to the tripod.
Use height adjustment handle (#8) to adjust the height of the
mount if needed. (Caution
: Do not extend beyond 6 inches.)
Make sure to tighten the tripod height extender lock (#12).
Step 3. Installing Batteries (not included)
Pull the batteries compartment cover (shown) open.
Gently pull the batteries holder (shown next) out of the
compartment to avoid breaking the attached wires.
Step 3a.
Insert 8 AA batteries (not included) according to the diagrams on
the holder.**
Replace the holder back into the batteries compartment and
replace the cover.
Note
: fit the batteries holder back into the compartment with the
attached wires at the bottom right corner (see arrow in the
photo).
** Use only fresh batteries; do not mix fresh and old
batteries;insufficient battery power may cause error
messages;optional AC Adapter and Car Charger
accessories are available at www.ioptron.com
Threaded
bolt #13
Height lock
(#12)
#10
#9
Height adjust.
(#8)