0
Owner's of the Bushnell Binoculars Night Vision 26 gave it a score of 0 out of 5. Here's how the scores stacked up:
5
4
To Activate The IR Illuminator
• Your Bushnell Night Vision Binocular includes a built-in infrared (IR) illuminator (5). This allows you to see in complete darkness
when no ambient light source is available.
• Press the IR button (4). This will activate the built-in IR Illuminator allowing use in total darkness over limited range.
• To turn the IR off after use, press the IR button (4).
To Focus
• Adjust the Eyepiece Focusing Rings (6) and Objective Lenses (7) for the sharpest image. When viewing from one object to
the next, it may be necessary to re-focus the objective lenses again.
Attaching To A Tripod
• There is a tripod attachment point mounted on the underside of the right bodyshell.
TROUBLESHOOTING
Spots in the Image.
You may see spots in the image. These vary from binocular to binocular and are cosmetic blemishes inside the scope. These
are normal for Night Vision binocular and are not a defect.
Binocular will not turn on.
Check that the battery was installed properly. Replace the battery with a new one. Check the battery contacts to ensure they
are clean and free of corrosion.
This night vision binocular contains a light sensor on the right side (8). This sensor is a bright light protection circuit. Do not
cover up this sensor when using in dark conditions. If focusing the unit during the day, (remember to do so with objective lens
caps on), you will need to cover this sensor with your finger or black electrical tape.
Image is not focused.
Adjust the focus on the Eyepieces. You must be at least 1.5 ft./ .46 meters from the subject you are viewing. If no improvement,
clean lenses, they may be foggy or dusty.
Visibility decreases or disappears.
Night vision devices work by amplifying available light - they need reasonable levels of natural moonlight/IR light to give good
results. Bright light sources such as headlights may cause visibility to degrade or disappear completely. Never point your scope
towards such bright light sources or switch it on in a bright environment/daylight with the lens caps off. If exposed to bright light,
protection circuits will turn the scope off automatically - it can function again after 1 or 2 minutes. Poor atmospheric conditions
such as fog or extremely dark environments will decrease the visibility of the unit. Infra Red light sources, which night scopes are
sensitive to, will increase range capability in very low light conditions.
Binocular flashes.
The binocular may flash when used in a bright environment. It may also flash during the first few seconds of use in dark
environments.
CARE & MAINTENANCE
• When not using for an extended amount of time, remove battery and store the product in a dry location.
• Avoid turning the product on in extremely bright light conditions.
• Handle this product like you would a camera. Though Bushnell Night Vision products are durably constructed, the image
intensifier tube consists of glass and is subject to breakage.
• Keep the optics clean. We recommend using a camera cleaner kit to clean the outside of the objective and eyepiece lenses.
Follow the directions with the kit.
• Do not disassemble this product. Unauthorized disassembly not only voids the warranty but may also cause damage from
the lack of special tools and techniques.
Find Your Products By Category
Please Login
