Bushnell Film Camera Bushnell Film Camera User Manual

0

Out of 0 Ratings

Owner's of the Bushnell Film Camera Bushnell Film Camera gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 72
 
7
OPERATIONAL SUMMARY
While looking through the 5x eyepiece, depress the POWER/FIRE button once to activate the in-view Liquid Crystal
Display (LCD). Place the aiming circle (located in the center of the field of view) upon a target at least 5 yards away,
depress and hold the POWER/FIRE button down until the range reading is displayed near the bottom of the in-view
display. Crosshairs surrounding the aiming circle indicate that the laser is being transmitted. Once a range has been
acquired, you can release the POWER/FIRE button. The crosshairs surrounding the aiming circle will disappear once
the POWER/FIRE button has been released (i.e. the laser is no longer being transmitted). Note: Once activated, the LCD
will remain active and display the last distance measurement for 30 seconds. You can depress the power button again
at any time to distance to a new target. As with any laser device, it is not recommended to directly view the emissions for
long periods of time with magnified lenses. The maximum time the laser is transmitted (fired) is 10 seconds. To re-fire, press
the POWER/FIRE button down again.
LIQUID CRYSTAL DISPLAY (LCD) INDICATORS
Your TOUR V3 ’s LCD incorporates illuminated icons or symbols that indicate the selected unit of measure, when the laser
is actively firing, when a target has been acquired, and targeting modes. A summary of these features follows:
MODE and UNIT OF MEASURE OPTIONS
The TOUR V3 can be used to measure distances in yards or meters. The unit of measure indicators are located in the lower
right portion of the LCD. To select between yards and meters, press and hold the POWER/FIRE button. The display will
begin to cycle through the setup options: Yards w/JOLT, Yards, Meters w/JOLT, Meters (for details on the JOLT feature,
see “About JOLT”). When the units and JOLT mode you want to use are displayed, release the POWER/FIRE button to
select it. If you are changing from yards to meters, a change in unit of measure will be indicated by the illumination of the
M for meter indicator while the Y for Yard indicator is turned off. If you are changing from meters to yards, the opposite
will occur. The TOUR V3 will return to the last unit of measure setting used each time the unit is turned on.

   Find Your Products By Category