0
Owner's of the iOptron Telescope MINITOWER-II gave it a score of 0 out of 5. Here's how the scores stacked up:
iOptronCorp.|6EGillStreet|Woburn,MA01801USA|(781)569‐0200|TollFree(866)399‐4587|www.iOptron.com
2
Quick Setup
Note: This is a brief outline for getting started. Please refer to the full manual at www.iOptron.com for details.
Step 1.
Extend tripod legs to full extension. Then lock legs using the lock knobs
on sides.
Step 2.
Assemble the three prong washer and azimuth clutch lock (#8) onto the
mount base. Do not fully tighten the AZI clutch lock yet.
Step 3.
Install three star-shaped adjustment screws onto the tripod head #5.
Carefully position telescope mount onto the tripod by aligning the three
holes on the bottom of the mount base (#7) to the three level adjustment
screws (#6) on the top of the tripod (#5), hold the mount with your hand.
Adjust level adjustment screws (#6) to level the mount using the bubble
level on the base. Rotate the mount to make sure the bubble is staying in
center, or stay in the same place. (An external torpedo level may help.)
Step 4.
Secure the mount to the tripod by using the long tripod bolt (#4). Thread
the bolt into the bottom of the mount by turning the tripod knob (#3).
Next, slide tripod support spread (#2) onto bottom of bolt (#4). Position
the three edges to fit against the three tripod legs. Then hand tighten
tripod lock knob (#1) to secure the tripod support spread in place.
Step 5.
Fine adjusting the three level adjustment screws (#6) to further leveling
the mount. Tighten the azimuth clutch lock (#8). Tighten the tripod knob
(#3). Tighten the tripod lock (#1). Make sure the mount is always leveled.
Step 6.
Attach telescope to Primary Dovetail Saddle (#10) using Primary Dovetail
Lock (#9).
#8
Washer
#10
#9
#6
#4 Bolt
#2
#3 Knob
#1
Find Your Products By Category
Please Login
