0

Out of 0 Ratings

Owner's of the iOptron TV Mount iOptron TV Mount gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 6
 
3
iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | Toll Free (866) 399-4587 | www.iOptron.com
5. InstallCounterweight(CW)Shaft:(1)RemoveCW
ShaftLockingScrew .(2)InsertCWShaftintotheCW
MountingNose.(3)ThreadintheCWShaftLocking
Screwfromtheotherside
.(4)TightentheFrontCW
PositionScrew.
CW Shaft Locking Screw
CW Mounting Nose
(1)
(2)
(3)
Front CW Position Screw
Rear CW Position Screw
[TIP:At very low latitudes (<10°), to avoid CW
bumpinginto tripodleg, turn theRear CWPosition
Screw (a hex head set screw) further into CW
Mounting Nose before tightening the Front CW
PositioningScrew.]
6. InstallCounterweight:RemoveCWSafetyCapatthe
end ofCW Shaft.With thewider openingtowards
theshaftend,guideCW throughthe shaft.Usethe
CWLockingScrewtoholdtheCWinplace.Place
SafetyCapbackontotheshaft.
[TIP:ZEQ25comeswitha10.4lbs(4.7
kg)CW,which
should besufficient for payloadsup toabout 13lbs
(6kg).UseextraCWorCWExtensionBartobalance
higherpayloads.]
7. Balance Payload:After attaching scope and
accessories, the mount head assembly must be
balanced in both R.A. and DEC axes to ensure
minimumstressesonthemountdrivingmechanism.
CAUTION:Thetelescopemay swingfreelywhenR.A.
orDECGearSwitchisopen.Alwaysholdontothe
telescope assembly before opening
the gear
switches to prevent it from swinging, which can
causepersonalinjury and/orequipmentdamage.
TurnTensionAdjustercounterclockwisetorelievethe
contact pressure.Turn Gear SwitchKnob by 90° to
the OPEN position to disengage the worm from the
wormwheel.
[TIP:Any hesitation in turning the knob
by 90°
usuallymeansthattheTensionAdjusterhasnotbeen
loosened enough; turn the Tension Adjuster
counterclockwisebyoneormoreturnsfurther.]
Tension Adjusters
OPENLOCK
Gear Switch
CAUTION:ThebalanceprocessMUSTbe donewith
Gear Switch at OPEN position!Otherwise it might
damagethewormsystem.
With the corresponding Gear Switch in the OPEN
position,balancetheassemblyinR.A.axisby moving
CWalongitsshaft,andbalancein DECaxisbymoving
thescope
withaccessoriesbackandforth(seephotos
below).
Onlybalanceoneaxisatatime.
CW Shaft inserts into
CW mountin
g
nose.