Bushnell Binoculars Bushnell Binoculars User Manual

0

Out of 0 Ratings

Owner's of the Bushnell Binoculars Bushnell Binoculars gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 15
 
1
Congratulations on the purchase of your Bushnell Night Vision Product. Bushnell Night
Vision products are comprised of high quality image intensifier tubes and optics. Bushnell
Night Vision products amplify existing light, allowing you to see in dark conditions too dark
for the naked eye.
HOW NIGHT VISION WORKS
Bushnell Night Vision products collect and amplify existing light through the objective lens,
which is then focused on the image intensifier. Inside the intensifier, a photocathode is
"excited" by the light and converts the photon energy into electrons. These electrons
accelerate across an electrostatic field inside the intensifier and strike a phosphor screen (like
a green monochrome TV screen) which emits an image that you can see. It is the acceleration
of electrons, which provides gain and enhances the image. This is a Generation I device.
Your Night Vision device is ideal for a variety of professional and recreational uses including
the following: Wild Life Observation, Astronomy, Boating / Marine Use, Police / Law
Enforcement, Search and Rescue, Security, and Property Management
GETTING STARTED
Installing Batteries
This device operates on one CR123 3-volt lithium battery. To install, unscrew the battery
compartment cover located near the objective lens. Insert the positive end of the battery into
the battery compartment leaving the negative end facing out. Replace the battery cover
carefully – do not over tighten.
Use and Testing
This device operates on one 3-volt CR123 lithium battery. Make sure it has been installed
according to the instructions above.
If you wish to test your night vision device in a lighted area, be sure the objective lens cap is
covering the objective lens prior to pressing the "ON" button. The objective lens cap has a
pinhole opening to admit a small amount of light for testing purposes.
If testing or using the device in the dark, remove the objective lens cap and activate the device
by pushing the "ON" button. The objective lens cap can be conveniently stored on the side
of the unit while in use in darkness.
Your Night Vision device offers a Built-In Infrared Illuminator. This allows you to see in
complete darkness where no ambient light source, such as moonlight, is available. To activate,
simply press the button located next to the "ON" button.
ENGLISH
ENGLISH 1-4
FRANÇAIS 5-8
ESPAÑOL 9-12
DEUTSCH 13-16
ITALIANO 17-20
PORTUGUÊS 21-24
CONTENTS

   Find Your Products By Category