iOptron Telescope iOptron Telescope User Manual

0

Out of 0 Ratings

Owner's of the iOptron Telescope iOptron Telescope gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 9
 
4
iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 935-2800 | Toll Free (866) 399-4587 | www.iOptron.com
Figure 11
4. Attach counterweight (CW) shaft
: Unscrew the CW
shaft from the top of the mount (Figure 12 top) and
thread it into the opening of the DEC axis (Figure 12
bottom).
Figure 12
5. Install counterweight(s)
: iEQ45 comes with two 5kg
counterweights. Use one or both of them for your
particular OTA (Optical Tube Assembly). An optional
CW shaft extension or additional CW is available for
purchase at www.ioptron.com.
6. Attach OTA to mount and balance
: After attaching
an OTA and accessories to the mount, the iEQ45
must be balanced to ensure minimum stress on the
mount (such as gears and motors inside). There are
four (4) Clutch Screws on both DEC and R.A. axes.
Please refer to the full manual for balance
procedures/tips.
7. Connect cables
: Attach one end of an RJ-11 cable
into the socket on the side of the DEC unit and the
other end into the DEC socket located on RA unit.
Use another RJ-11 cable to connect the hand
controller to the HBX socket located on the RA unit.
Plug 12V DC power supply into the POWER socket
on RA unit. The red LED will be on when the power
switch is turned on.
8. Setup Controller:
The time and site information of
the observation location needs to be entered for
precise GOTO.
Turn the mount power on. Wait for controller lights on.
Press the MENU button. Move the cursor to “Set Up
Controller” and press ENTER. Select “Set Up Time
& Site” and press ENTER.
Figure 13
Enter the date and check if it is Daylight Saving Time
using arrow keys and number keys. Enter your time
zone (add or subtract 60 minutes per time zone) by
entering minutes “behind” UT or “ahead of” UT, such
as:
• Boston is 300 minutes “behind” UT
• Los Angeles is 480 minutes “behind” UT
• Rome is 60 minutes “ahead of” UT
• Sydney is 600 minutes “ahead of” UT
All the time zones in North America are “behind” UT.
You may also find your observation longitude and
latitude coordinate from your GPS navigator, a GPS
capable cell phone or from internet. “W/E” means
western/eastern hemisphere; “N/S” means
northern/southern hemisphere; “d” means degree; “m”
means minute; and “s” means second. Use number
keys and arrow keys to enter your location information.
Move the cursor to the end of the screen to select
Northern or Southern Hemisphere.
9. Polar alignment: In order for an equatorial mount to
track properly, it has to be accurately polar aligned.
With the proprietary AccuAligning
TM
Polar Scope and
Quick Polar Alignment procedure, you can do a fast
and accurate polar alignment.
Lat. Safety Lock
Locking Screw
Upper Position
Lower Position
Lat. Adjust. Knob
Lat. Adjust. Lever

   Find Your Products By Category