Bushnell Laser Level FUSION 1600 User Manual

0

Out of 0 Ratings

Owner's of the Bushnell Laser Level FUSION 1600 gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 156
 
26
TROUBLE SHOOTING TABLE
If unit does not turn on - LCD does not illuminate:
• Depress POWER button.
• Check and if necessary, replace battery.
If unit powers down (display goes blank when attempting to power the laser):
• e battery is either weak or low quality. Replace the battery with a good quality
3 -volt lithium battery (CR-123).
If target range cannot be obtained:
• Make sure Display is illuminated.
• Make sure that the power button is being depressed.
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target) that emit
and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
NOTE: e last range reading does not need to be cleared before ranging another target. Simply aim at the new target using
the display reticle, depress the power button and hold until new range reading is displayed.
Specifications, instructions, and the operation of these products are subject to change without notice.
FCC NOTE
is equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. ese limits are
designed to provide reasonable protection against harmful interference in a residential installation. is equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Complies with 21 CFR 1040.10 and 1040.11 for laser products except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007

   Find Your Products By Category